3/8 scale. Hopper just fits a 220mm X 220mm table. From drawings in a 1972(?) Model Railway Constructor(?). Peter Davis
Models
3D Model
3D Model
This is an altered copy of the axle box on Peter Jackman's 16T mineral wagon.
3D Model
These are copied from the brake gear on Peter Jackman's 16T mineral wagon and altered to suit.
3D Model
These are copied from the brake gear on Peter Jackman's 16T mineral wagon and altered to suit.
3D Model
I printed mine in ABS.
3D Model
3mm x 62mm piece of ground rod needed for each axle
3D Model
This might be a challenge to make. I had better results with a .2mm nozzle.
3D Model
3D Model
3D Model
3D Model
3D Model
Drill and tap 0-80 or 10 BA
3D Model
3D Model
3D Model
3D Model
3D Model
3D Model
2 mm hole is to assist gluing together each half stanchion.
3D Model
Print up side down. I've included a center support (removable after printing) so no other support should be necessary. I've printed three, layer .2mm, print speed increased to 100mm/sec. Actual print time 8 Hr. 54 Min.
Reviews/Comments (subject to moderation)