Multiple piece kit style 10 mm scale. From drawings found in "Historic Wagon Drawings in 4 mm Scale" by F.J. Roche. And information found in the G1 NL&J. #250. By Peter Davis
Models
3D Model
3D Model
3D Model
3D Model
3D Model
3D Model
3D Model
3D Model
3D Model
alternate choice of end
3D Model
3D Model
3D Model
Folders
Folder
Title
Long roof, floor and frame
Notes
Special for those who have large capacity printers
Models
3D Model
Printable floor 17.46 Long
3D Model
Full length frame, 17.7" long
3D Model
inside brace, shortened to clear printed roof.
3D Model
3D Model
Roof with 16 inches of center length removed to make quick test print.
Folder
Title
Roof(4 pc), Floor(2 pc) and Frame (2 pc).
Notes
Printable on 220x220 table. Floor and Frame Diagonally.
Images
General assembly for printed roof and frame
Models
3D Model
Shorter inside brace to allow for printed roof.
3D Model
Print diagonally. Print Two. Dowel with bits of filament to frame.
3D Model
Print diagonally. Print two. Dowel and bolt together.
Select "None" instead of Brim or Skirt if you need space.
(updated 1 Aug 2022. Hole for truck mount opened to 4.2mm)
Select "None" instead of Brim or Skirt if you need space.
(updated 1 Aug 2022. Hole for truck mount opened to 4.2mm)
3D Model
Print Two, dowel together with filament
3D Model
Print Two, Use Short bits of filament as dowels
Folder
Title
Truck
Notes
Sides printed in two pieces to minimize supports.
Uses: six, M2 x 10mm flat head screws with M2 x 4mm hex nuts. 4 pieces, K&S brass tube 4mm od x 3mm id x 6mm long. 2 pieces, 3mm steel ground rod 62mm long. 4 washers .5mm thick.
Tighten screws enough to remove excess play. Use tread lock(low Strength).
Images
Models
3D Model
3D Model
3D Model
Updated 1 Aug 2022. Mounting hole changed to 4.2m
3D Model
3D Model
Use Northern Fine Scale wheel/axle sets should you prefer.
Reviews/Comments (subject to moderation)