This type of wagon was originally in shiny polished stainless steel.. However later editions were as per the picture
Documents
Document
I hope this makes things clear!. Point to note. The cylinder is not symetrical on the chassis being nearer one end than the other.The lower part of the cylinder also has the support frames At each end these have what I have described ad strengthening
plates. These are printed with the support bracket. These plates have a bit that extends over the frames. These are coincidenr with the centre line of the bogies
plates. These are printed with the support bracket. These plates have a bit that extends over the frames. These are coincidenr with the centre line of the bogies
Document
Details to follow
Models
3D Model
3D Model
3D Model
This is the first of the bottom part of the cylinder These are best printed on their end
Amended to give cutout for crossmember and altered profile
Amended to give cutout for crossmember and altered profile
3D Model
Part 2 of the bottom cylinder
3D Model
Five needed if cylinder has been split into 4
3D Model
See previous note on railing 1
3D Model
This is one quarter of the top cylinder for those who cannot get the height (230mm) of the half cylinder Two of these are required
3D Model
This is the other quarter of the top of the cylinder
3D Model
two of these are needed. The sole bars have slight cut outs to locate
3D Model
Dont forget to put a nut (Locknut ) in before assembly!
3D Model
3D Model
Part 3 of the bottom
3D Model
Fourth part Amended to show opening for cross member
3D Model
Two are required. Some adjustment may be needed to get a good fit
3D Model
I think this is part of the brake cylinder
3D Model
this has holes for the railings
3D Model
One as drawn one mirror
3D Model
3D Model
This footplate is at the end with the railings
3D Model
3D Model
4 needed see note regarding railings
3D Model
3D Model
3D Model
3D Model
3D Model
TYwo required One as shown one miror irrormage
3D Model
3D Model
Railings and ladders can be printed in PLA or resin but are quite fragile. Best made from 1.5mm rod (Brass)
3D Model
Straightforward
3D Model
3D Model
Four of these are required, two as shown 2 mirror images
3D Model
3D Model
This is half of the cylinder top and printed on end requires 230 mm
Reviews/Comments (subject to moderation)